Step by Step Tutorial : How to integrate SCOM 2012 R2 with SCVMM 2012 R2

Step by Step Tutorial : How to integrate SCOM 2012 R2 with SCVMM 2012 R2

Integrating SCOM 2012 R2 with SCVMM 2012 R2 is pretty easy. There are a few important pre-requesties that needs attention. All the needed articles to integrate SCOM 2012 R2 with SCVMM 2012 R2 are mentioned below in the references section of this tutorial.

Steps :

1) You can connect Virtual Machine […]

Read More

How to rename a Failover Cluster in Virtual Machine Manager 2012 R2

Problem Description :

In case of you renamed a Failover Cluster in Failover Cluster Manager which is connected to a SCVMM 2012 R2 you will see that the renaming will not be reflected in SCVMM 2012 R2.

Solution :

Under these circumstances you can basically rename the Failover Cluster over the VirtualManagerDB […]

Read More

After configuring VM properties in SCVMM 2012 R2 you can receive the following error message. VMM is unable to process one or more of the provided cmdlet parameters. ID 1600

Problem Description :

After configuring VM properties in SCVMM 2012 R2 you can receive the following error message when you try to apply the settings.

VMM is unable to process one or more of the provided cmdlet parameters.
Type Get-Help Set-SCVirtualMachine -full to view a list of defined parameters and complete […]

Read More

Virtual Machine Manager 2012 R2 may show CPU Average of Virtual Machines [VM’s] as 0 % percent

Problem Description :

Virtual Machine Manager 2012 R2 may show CPU Average of Virtual Machines as 0 % percent. This problem can caused by the Hyper-V Nodes, VM’s and also from the VMM Server itself therefore to not spend to much time with troubleshooting this problem I would suggest […]

Read More

Most misunderstood Virtual Machine Manager 2012 R2 Feature

One of the most misunderstood feature in Virtual Machine Manager 2012 R2 is the cross migration of Virtual Machines from one Hyper-V Failover Cluster to another Hyper-V Failover Cluster or from one Standalone Hyper-V Host to a Hyper-V Failover Cluster.

Cross migration capability is provided by Hyper-V and […]

Read More

How to troubleshoot “Error (15020) The virtual network adapter NetAdapterName [MAC: 001FFD8Z71C82] doesn’t have a CA (customer address) assigned from the VMSubnet related IP Pool”

Problem Description :

Virtual Machine creation over the WAP Portal can fail with error 15020.

Error Message :

Error (15020)
The virtual network adapter NetAdapterName doesn’t have a CA (customer address) assigned from the VMSubnet related IP Pool.

Recommended Action
Please assign a CA address from the VMSubnet Address Pool to the virtual […]

Read More